i have two airdog pumps, the one came off my pulling truck its a AirDog II 165 and has 0 street miles fits 94-98 12valves. complete kit wiring, mounting brackets, fuel line are all new i made my own setup for the truck has maybe 10 hours run time on it. $450 shipped

the other one is an airdog 150 that came off my 04.5, has arround 10,000 miles on it, complete kit everything needed to install. fits 05-09 dodges $350 Shipped

B&W turn over fith wheel came off the 04.5 wont ship local pickup

also have a ppe rail pressure gauge new in the box, $125

2.6 Garrett gt42 turbo, has 1/8 wheel protrusion, Schied and TS legal has 16 pulls on it. work was done by columbus diesel. $1100 Shipped


Selling these parts because i lost my job and the wife doesnt make enough for me to keep all my toys and pay the mortgage. Both trucks are sold don't have anything else left.

 

man i hate to hear that, i am interested in the AirDog 11 165, does that have the big draw straw? an what size fuel line is it?

 

yeah it sucks but i had to do it. its 1/2 fuel line and comes with the 1/2 upgrade kit that goes into the sending unit

 

What is the difference between the 04.5 and the 03 Airdog setup?
Looking for one for my 03. If I can "make" this work, I may be interested. Thanks

 

the only difference is the wiring harness, the 03 uses the factory plug for the triger wire to open up the relay and the 04.5 and up uses a wire that runs back toward the tank, it wouldnt be hard to make it work

 

hmmmmmm.

 

can i get pics and specs on the turbo......

 

there any way the airdogs can be used on a 24v? what all would have to be adapted to get it to fit the vp?

 

if you wanted the 165 airdog you would have to turn the pressure down, and do a little wiring for the trigger wire, i have an extra fitting that goes into the vp44 so that should be it. and for the 150 just change some wiring and it will be good to go.

 

Wouldn't be willin to trade anything for that airdog 150 would ya?