Used Holset 21CM Exhaust Housing For Sale
#11
rings while your putting the other 2 bolts in The ends of the rings have arcs cut in them and when both rings are on that's where the bolt goes like so
Reference picture only
Leave the bolts hand tight
Here's the new set up HX35W With A 16 Cm Exhaust Housing
Put the charger on the truck using the Exhaust Gasket (BUBBLE OUT) and connect the charger to the Exhaust Manifold.
Spin the charger around to where the Intercooler line is perfectly lined up then tighten down all 4 bolts connecting the Exhaust Housing and the Compressor Housing
Finish putting the charger on and you're done
Refer to the Charger Swap Guide for further information
Reference picture only
Leave the bolts hand tight
Here's the new set up HX35W With A 16 Cm Exhaust Housing
Put the charger on the truck using the Exhaust Gasket (BUBBLE OUT) and connect the charger to the Exhaust Manifold.
Spin the charger around to where the Intercooler line is perfectly lined up then tighten down all 4 bolts connecting the Exhaust Housing and the Compressor Housing
Finish putting the charger on and you're done
Refer to the Charger Swap Guide for further information
#19
well see im looking for future mods so if i get the housing because im gonna be puttting head studs and injectors in within a month or two just didnt know how much lag im gonna be running two chips and then the housing for now untill like i said the injectors i mean any sugestions for me i mean i have lag now but im looking fo rmore boost
Thread
Thread Starter
Forum
Replies
Last Post
Jet A Fuel
6.7 Liter Dodge Cummins 07.5-12
3
08-03-2015 10:45 AM
carid
Diesel Bombers Sponsors
0
12-12-2014 02:26 AM