95 Cummins Engine (Whole or Parts)
#1
95 Cummins Engine (Whole or Parts)
Well unfortunatly I have to get rid of my project engine.
The engine is out of a 95 2500, truck had 212K miles. It is a 160 motor. I took it apart down to a long block. Did run when pulled, but it sat around and #6 got water in it, and it rusted. I think the head gasket seeped while it was out, it was inside. So i pulled it apart so i could rebuild it, but i just dont have time or money.
This engine does turn over, just needs a rebuild.
I have everything, wire harness, exhaust manifold, starter, P7100, bell housing, flexplate, head to oil pan. Entire fuel system, LP, FF, IP.
i have no clue what this is worth, give me your best offer.
i will sell parts off of it, or the whole thing.
Hopefully someone else can get good use out of it.
The engine is out of a 95 2500, truck had 212K miles. It is a 160 motor. I took it apart down to a long block. Did run when pulled, but it sat around and #6 got water in it, and it rusted. I think the head gasket seeped while it was out, it was inside. So i pulled it apart so i could rebuild it, but i just dont have time or money.
This engine does turn over, just needs a rebuild.
I have everything, wire harness, exhaust manifold, starter, P7100, bell housing, flexplate, head to oil pan. Entire fuel system, LP, FF, IP.
i have no clue what this is worth, give me your best offer.
i will sell parts off of it, or the whole thing.
Hopefully someone else can get good use out of it.
Last edited by Cumminsdieselboy; 09-09-2008 at 08:30 PM. Reason: Forgot mileage
Thread
Thread Starter
Forum
Replies
Last Post
burndiesel
24 Valve 2nd Gen Dodge Cummins 98.5-02
10
02-07-2023 01:15 AM
mountainmover
Big Rigs & Semis
0
03-01-2015 06:03 AM
mcclusk
24 Valve 2nd Gen Dodge Cummins 98.5-02
3
02-21-2015 09:50 PM