Here are some pics of a new design for the 2nd gen short bed 4x4s with a one piece drive shaft. I had to go a different route on these because of the larger bulge around the front fuel tank strap. This is a very light weight race loop that will bolt on the factory tank support in four places. It is available with the Cummins "C" or without, in three standard powder coat colors RED, BLACK, and SILVER. It runs $88.00 and includes shipping in the good ol USA.

Please let me know what you guys think, you feed back is very important to me!


Thanks
Aaron/HD Fab

 

The C is a nice touch

 

Im trying to make the best looking loops available....

 

I am sorry I have not had a chance to get those pics to you.

Do you still need them?

 

I think I have it covered.... made a few changes, and I think its all good.

 

I need a loop for a 97 SCDRW 4x4with a single driveshaft, i will be sled pulling some.

 

Im still working on the shield design for the pullers. Ill post up the info when they are available.

Thanks,
Aaron/HD Fab

 

Dang those look good!!!!

 

FYI... I am bringing down an assortment of loops to the Ennis race this weekend. Let me know if you need/want anything...

 

Thanks to everybody that made it down to the Ennis race in Texas over the weekend! We had a decent turnout even though it was 42 degrees, and windy as can be.
Dr performance was nice enough to let me put my loops on there vendors table, and I had a blast spending a couple days with them at the track and at there shop. They are a super nice bunch of guys, and if you ever get the chance be sure to go over and say hi. I was able to put my hands on some of the new products, including the motor blankets for the Cummins.

Thanks again for all the nice comments on the loops guys!!

Aaron/HD FAB