Hi guys i am new here i have a 1999 early model fsd 7.3 has new injectors glow plugs valve cover gaskets wireing to injectors and glow plugs glow plug relay fuel filter heater still has trouble starting cold im thinking hpop how do u check to c if bleeding down alsotruck has 235000 miles been great till last coupple months any ideas would help thank john

---AutoMerged DoublePost---

I could really use some help here im completely stumped as to what could b wrong!

 

To check the HPOP reservoir level, you pull the plug on the top of it and stick something down in there...

Have you done a compression test?

 

Ididnt the shop that put injectors in said it was even and good!

---AutoMerged DoublePost---

What i dont know is if it is bleeding down what could cause it?

 

It's possible but I don't think it's your problem... Does the truck start fine when warm or if you plug it in?

 

Where im at there is no place to plug in what i did notice is very little white smoke when it does start! I did glow plugs relay and filter heater on inside of filter have the one for ojtside of just havent had a chance to put on yet it used to atleast try to start now dont even try i did notice oil pressure gage reads nothing at all until it starts? ????????

 

How are your batteries? How old is the oil? Where did the injectors come from? Some more info would help I think... Did this just all of a sudden happen or what?

Do you have access to a scanner?

 

Batteries r good new plus new starter and cables

---AutoMerged DoublePost---

Started coupple months ago

 

Where did you get your injectors from?

When it starts does it romp at all? Or just start and blow some smoke for a few seconds?

Have you checked the glow plug relay to insure its working? Turn the key on and check it with a test light, if your not getting power across it, your not getting power to the glow plugs!

 

Just starts and runs normal. Have checked working good

 

I thought this thread was started because it won't start... It does start and run sometimes?