I have a set of autometer c2 gauges for my truck that I'm trying to install. Where can I get an electronic sender for the transmission temp gauge? My truck has no sending unit to begin with, and the harness for the gauges has a 2 port female clip on it not a ring connector. Where would it get put into on my e99 4r100?

 

if you look at the tranny on the drivers side, a little bit forward of the linkage just above the pan i believe there is a plug right there. there is one there on my buddies 2000. the guage set didn't come with the temp sender?

 

No didn't come with the autometer map sensor either for boost

 

who did you get it from? i would call them and see what they say.

 

Froa member on the org that is no longer around. They were new never installed still sealed in the box

 

well if that's the case i would call autometer and see if you can get the sensors from them. do you have the EGT probe?

 

Yes I got the EGT probe, just not the trans temp sensor, or the map sensor

 

Like he said there's a plug just in front of the linkage pull it out and put the sensor in its like a 8mm bolt, I would go to oreillys and see if the gauges are supposed to come with the sensor, and if not they could order u one,

 

Call Autometer and get the proper sender... They will be the same for the C2 and for the Cobalt...

 

Thanks. I got ahold of them today and those parts are on the way