SS x-over pipe calcs for the DIY'r
#1
SS x-over pipe calcs for the DIY'r
So I was bored today and decided to do the stress analysis calculations to determine which pipe vs. wall thickness is necessary to make the x-over pipe for the oil system.
I took 400 Degrees Fahrenheit to be safe, and decided the minimum safe working pressure to be 4000 PSI.
I hope the charts make sense, I yellowed out anything below 4000 PSI as not being safe.
I'll publish a DIY on the x-over when I finish mine and show you how it can be done safely and easily at home with easily obtained materials.
I took 400 Degrees Fahrenheit to be safe, and decided the minimum safe working pressure to be 4000 PSI.
I hope the charts make sense, I yellowed out anything below 4000 PSI as not being safe.
I'll publish a DIY on the x-over when I finish mine and show you how it can be done safely and easily at home with easily obtained materials.
Thread
Thread Starter
Forum
Replies
Last Post
ebg2g
5.9 Liter CR Dodge Cummins 03-07
1
03-29-2015 06:15 PM