need help fast
#1
need help fast
I was driving down the road and the truck just shut off replacd the CMS and that didn't work. Truck finally pulled p1670 code. Got ahold of a generic scanner and it showed no power to the injectors. Is this most likely the IDM, PCM, UVC? Or am I missing something? Also, where can I find wiring diagram for the truck? 2001 Ford F350 7.3PSD. Thanks. Have Edge Evo would that programmer have fried IDM or PCM?
#2
#4
#5
I unplugged IPR and tried to start it then it ran p1280 code so that should be working. What are the odds that both UVC harnesses are unplugged or bad?
---AutoMerged DoublePost---
Just unplugged glow plug and injector(plug on top of valve covers) wiring reads 4 amps would that inticate IDM is working?
---AutoMerged DoublePost---
Sorry I wrought amps I meant 4 volts. Also checked harness at IDM and the #2-8 injectors read 3.5-4.1 volts, #1 injector reads open or infinite resistance. What the heck is going on? Could one bad injector shut down the truck? Thanks again for the help.
---AutoMerged DoublePost---
Just unplugged glow plug and injector(plug on top of valve covers) wiring reads 4 amps would that inticate IDM is working?
---AutoMerged DoublePost---
Sorry I wrought amps I meant 4 volts. Also checked harness at IDM and the #2-8 injectors read 3.5-4.1 volts, #1 injector reads open or infinite resistance. What the heck is going on? Could one bad injector shut down the truck? Thanks again for the help.
Last edited by brando; 09-25-2009 at 05:39 PM. Reason: Automerged Doublepost
#6
#9
Thread
Thread Starter
Forum
Replies
Last Post
Gm3500
Chevy/GMC 6.2L and 6.5L
9
05-07-2015 11:01 AM
stevenb86
5.9 Liter CR Dodge Cummins 03-07
2
03-08-2015 10:02 AM