99 PSD no start - no smoke - hair on fire
#21
PowerStruck: I am on it, ill try to follow it, but again no one around here seems to be able to do the reading correctly ala the language of powerstroke
Bestrada11: that is a very gracious offer, the 'chip' thing is above my pay grade but I am trying to see what the super chip can read. Ill try to get a UPS acct # ASAP
I am near Erie Pa right now. Spent 30 yrs in Baltimore and due to an admitted addiction problem, have the crab jts number above my desk.
Don't like Seafood .... name your poison. We get as few as 55 days of sun here and Casper has used up 3 this wk / it is getting personal
Bestrada11: that is a very gracious offer, the 'chip' thing is above my pay grade but I am trying to see what the super chip can read. Ill try to get a UPS acct # ASAP
I am near Erie Pa right now. Spent 30 yrs in Baltimore and due to an admitted addiction problem, have the crab jts number above my desk.
Don't like Seafood .... name your poison. We get as few as 55 days of sun here and Casper has used up 3 this wk / it is getting personal
#24
Bestrada11
Superchips says it will read codes / as well as other readers / I dont know
I would like to try
I have a UPS account / please contact me at mbarnes.cm@gmail.com or
814 789 3024 hm
410 409 9177 cell
thnx
Superchips says it will read codes / as well as other readers / I dont know
I would like to try
I have a UPS account / please contact me at mbarnes.cm@gmail.com or
814 789 3024 hm
410 409 9177 cell
thnx
#26
THNX to the heroics of bestrada11 I got a reading today of:
PO340 � CMP Camshaft position sensor ckt. malfunction ----- Open/grounded circuit, sensor fault, short to power
(CMP changes 4 x, wire replaced in harness / I am getting RPM (160) to reader and gauge inside)
P0603 � PCED Internal control module KAM error ---- Open PCM pin, disconnected B+, faulty PCM
P0472 b EBP Exhaust back pressure sensor circuit low input ----- Open/grounded circuit, biased sensor, PCM
P1210 b ICP ICP above expected level ---- ICP sensor, open signal return
Any ideas on where to start
thnx
PO340 � CMP Camshaft position sensor ckt. malfunction ----- Open/grounded circuit, sensor fault, short to power
(CMP changes 4 x, wire replaced in harness / I am getting RPM (160) to reader and gauge inside)
P0603 � PCED Internal control module KAM error ---- Open PCM pin, disconnected B+, faulty PCM
P0472 b EBP Exhaust back pressure sensor circuit low input ----- Open/grounded circuit, biased sensor, PCM
P1210 b ICP ICP above expected level ---- ICP sensor, open signal return
Any ideas on where to start
thnx
#28
'a 3 wire sensor shorted to ' (Vref)
come again
a three wire shorted to ground??
thnx
---AutoMerged DoublePost---
Can anybody define what was meant by Vref
was that a Typo?
Or something I should be moving on?
thnx
come again
a three wire shorted to ground??
thnx
---AutoMerged DoublePost---
Can anybody define what was meant by Vref
was that a Typo?
Or something I should be moving on?
thnx
Last edited by mrjunks; 06-15-2013 at 11:55 AM. Reason: Automerged Doublepost