Ok so last night im pretty sure on my ride home i lost a brake pad because i heard a clunk and lost stopping power shortly after had pressure just nothing was there now come to today and getting ready to pull it in the shop i put it in neutral doesnt go anywhere i put it in reverse does the same as neutral but with hitting the gas it acts like the brakes are hung up or the e brake is on i havent torn it apart yet but im stumped so any help would be awesome!

 

Auto or manual?

 

Its an auto i found the problem the jerkoff who did my rear brakes from what i saw i guess he felmt it was necessary to beat my right rear rotor back onto the hub and put a slight hairline crack in it so when i clamped on the brakes the other night it sheared part of the inner side of the rotor off i lost a brand new pad and i hit the brakes again not knowing this had happened (under cab exhaust drownded the sound out) a cylinder grabbed bare steel and jerked it out of the caliper which was obviously causing the motion problems so needless to say i have quite a bit wrong at the moment (facepalm)

 

revoke his hammer privileges !