HPOP
#1
HPOP
Hi,new member, I replaced my the non-repairable plug on my 95psd,now i can not get it started,resivour is full,crank case is full,full of fuel,g/p's work,block heater plugged in,if i
spray fuel into intake truck runs,batteries are good, unhooked ICP to fool PCM.
I think i missed something,but what it is i do not know yet, about 200rpm while cranking
oil pressure comes right up. any ideas would be appreciated,thank's
spray fuel into intake truck runs,batteries are good, unhooked ICP to fool PCM.
I think i missed something,but what it is i do not know yet, about 200rpm while cranking
oil pressure comes right up. any ideas would be appreciated,thank's
#3
#5
#7
You need to get a scanner on it, check the ICP pressure and duty cycle.
Bet money you are getting about 200psi at 70% duty cycle...
#8
HPOP
Well took it to a garage they said HPOP was toast and maybe ICP, wanted about $1700.00 to
fix,brought truck home will buy a pump and change it ourselves. Can get a pump from shop i have dealt with before,pump is $562.00 instead of $921.00 from ford,the shop that did the scan said the ICP may or may not be bad.
Pulled plugs on head to suck as much old as possible.
The truck has 267,000 miles on it.
fix,brought truck home will buy a pump and change it ourselves. Can get a pump from shop i have dealt with before,pump is $562.00 instead of $921.00 from ford,the shop that did the scan said the ICP may or may not be bad.
Pulled plugs on head to suck as much old as possible.
The truck has 267,000 miles on it.
#9
#10