Powertroke wont start
#1
Powertroke wont start
hi everyone. I have a 1995 f250 7.3 powerstroke. I blew an high pressure oil line at high rpms, replaced it, ran the **** out of the truck 'til all the air was out of the hpop. I washed the oil from under the hood, cause it was a big mess, then I parked it. the next morning I started it up and ran as it should, I got a mile down the road and it lost all power and after a couple seconds died. I tried to start it but all I could get from it was a little pop every few second of cranking. later that night I cranked on it for a while and got it to fire but it was running on probably 2 cylinders and if I tried to rev it would die. today I hooked a scanner to it and it said the icp sensor was low of voltage or something in that neighborhood. but I unplugged the icp and it still wouldn't run. also it said that the sgc singal was bad and the kam internal control module error. I need hel. this trucks been sitting since october and I need it. thank you for your time and help.
#5
#7
#9
Thread
Thread Starter
Forum
Replies
Last Post
Cavnar
Diesel In Distress - Support Ticket
3
09-09-2015 07:18 PM
cjgregory
Diesel In Distress - Support Ticket
0
03-31-2015 01:45 PM
ronstop
5.9 Liter CR Dodge Cummins 03-07
0
02-26-2015 09:48 AM
carid
Diesel Bombers Sponsors
0
11-18-2014 06:49 AM