I have no lights
i have no high beam lights

i checked the fuses under the dash

they both are dead ...no power on both sides

the passing lights come on when i pull up on the turn signal lever....

i tried manualy turning headlights on using the switch

any ideas

 

Try using the tilt column and see if the lights come on at all.... probably a bad ts switch under the column, but it might just be loose.

 

Check the connectors....found mine burnt up when experiencing the same issues.

 

When did you notice this problem? Did it happen at random or after hard bump or rain ect? I had a very similar problem in my jeep what happened to me was water got in the compartment where all the relays were under the hood while I was off roading. I don't know if this is your problem though because I'm not sure if these trucks have a relay for the lights also when my relay went out so did my radio door locks and windows. Worth a shot though. If all else fails I'd follow the wires checking for cracks and melted wires

 

Are you running super bright light bulbs, correct me if I wrong but I thought some of those super bright bulbs draw more and are hard on factory relays.....thstd why I returned mine and put regular bulbs in!!!

Sent from my GT-S5830D using Tapatalk 2

 

yes using bright lights
the kit using transformers

even the high beam does not work
only pulling up on switch on column (passing)

no power on both left and right head light fuse

is there a relay for lights

 

Did you try the tilt steering? There's a switch right under the column plastic...

 

so the tilt steering shuts off the lights

I have no power on both head light fusses and the high beam

both sides of the fuses are dead

---AutoMerged DoublePost---

i can not believe it....

I pulled the tilt steering back and bingo the high and low lights work

so i kept playing back and forth ....<<

they still work

Thank You

I guess i have to remove the sterring column plastic covers to check it out

 

Correct! It's probably just a loose connection on that switch under there. I was just reading about this, guy said he took it apart, cleaned up the connections and taped it up and it worked fine!