lifted trucks r fer homo's

welcomde to the site

 

good one

 

So you have a 2" leveling kit and you already have 38x15.50s on it right now? How does that work? 37's rub on some 6" lifts I've seen....

 

i dont know , i bought a set of used 37 and the guy said i needed a 2 inch leveling kit to fit them . then when those wore out i found a set of barely used 38's and they dont rub either . needless to say i was amazed to. if i cud get the pics to upload id have pics of it up . dont know if pics are to large or what ...

 

make sure you post pics when your done bud

 

Did u cut the fender wells out to fit them tires cause my 6.5inch lift
would barely fit 38's if i tried to put some in there.

 

If it's on stock rims i don't understand this either? But if he has the tires on aftermarket wheels the offset could be set to not have any rubbing

 

Offset or not, that tire is just too darn tall! My buddy had 37's on 17x9 pro comps and those rubbed with 6.5" lift in the front.

I've heard of some guys getting away with 37's on a leveling kit, but never seen it. Either your fenders are cut or you already have some sort of a lift.... I just can not believe a 38 x 15.50 would fit.... that's insane!

Host the pics on photobucket and then link it here.

 

iv been trying to post pic of it like it is right now but it keeps telling me upload of pic failed..... is it because im a newbie and limited to how much i can do

---AutoMerged DoublePost---

i didnt have to trim , adjust , remove or anything other then install a leveling kit (2 inches ) and im running the factory harley davidson twenty inch rims . i couldnt believe they fit either but they do barely

---AutoMerged DoublePost---

i put a link to my facebook , and put truck as profile pic . go take a look and if the facebook link doesnt work let me know .

 

they do fit...they do rub slightly...on the radius arms from the positive offset of the factory rims...i think that also keeps them from hittin the fenders since they are tucked up under the truck and dont stick out