I'm interested, I have a 2003 with 130000 mi. and have only replaced 1 injector. It runs pretty rough until it's warmed up good.

4" turbo back straight pipe no cat no muffler
sct with eric's extreme race

 

Thanks, guys!
They are still looking for people with specific problems to see how the truck responds to the RevX, so guys, keep posting up!

 

I'll try any thing. I have an '03 F250 6.0 with 225K miles. It starts ok, but idles rough and is hesitant to accelerate until it's warmed up.

 

When i start my truck in the mornings it's super rough and blows out white smoke. and if i try to drive it before the oil temp gets to 150* or higher it shoots out alot of white smoke and misses and jerks and i have very little power.

 

I have to agree with the above 150* oil temp. Mine never runs good till it gets above the 150 mark and if it has set just long enough to go under the 150 mark it will be bad until it goes above it again. Just wondering if there is something that changes in the programming above 150?

 

im game. 06 99500 miles mods r in the sig. truck ride like a buckin bull in the mornings even if i let it idle for 10 min (even though its 60 to 70 outside) and will do the same thing if the truck sits for more than 3 hrs or so (even though its 80s out during the day)

on a side note trucks about to get an egr delete and sct tuner

 

Thanks for all the feedback! This is really good. Keep posting and telling what's going on with your truck--it'll help us determine which trucks to use in the 10 for the testing.

If you guys want to PM me with your contact information ahead of time, that would be fine, then it'll be faster in the end of the week when we will get ahold of those of you who are a good match for the trial.

Thanks guys!

 

I'm glad to see I'm not the only one having issues for one.

 

i feel the same way...here i though my truck was just gettin back at me for hittin that curb...

 

I have a few questions, What oil is everyone using? How often are you supposed to add the rev-x? If you can increase drain intervals, By how much? and do they want an oil analysis(before/after)? Thanks.