Truck Won't Start. Please Help.
#11
The IPR will come out pretty easy once you pop it loose. If the screen is good then it could be the STC fitting if that hasn't been replaced yet, they usually give a hot no start at first then go down hill from there, they can also "just fail" and stall out and not restart. Again, check the IPR first.
It finally started "Thank God" It was the IPR I think my other one was bad or maybe I had to clean it better, but I put the new one in and it started, after cranking for a long while. I must of flooded it some how while it was sitting there, cause it blow a lot of smoke for a while then I drove it around for a while and it cleared right up.
I still have the p0266 code, but hopefully the Acrhoil will clear it up.
bobfbigman thanks for all the help and time, God Bless.
Thread
Thread Starter
Forum
Replies
Last Post
doublehbar
24 Valve 2nd Gen Dodge Cummins 98.5-02
13
08-09-2015 12:35 AM
mountainmover
Big Rigs & Semis
0
03-01-2015 06:03 AM
ronstop
5.9 Liter CR Dodge Cummins 03-07
0
02-26-2015 09:48 AM