Anyone ever played with this???

Thinking if I could find the signal wire, and then the feed wire, its easy from that point. Then I could just bypass the damn thing...

Someone on here found them for 125 bucks shipped, but chripes I can get a relay for about 30 bucks and be done.

 

i know it would be more expensive but could you run a wiring harness from a SD?

 

Yes and no... The PCM will be looking for feed back from the GPCM, so you would have to swap the PCM as well. And then I am not sure if the pinouts are the same on the main harness...

Thinking it could be done with a few wires and such, but I may just bit the bullet and get a new one for $125 shipped...

 

i wasnt sure if they used the same PCM or not.