95 ram 2500 track bar replacement
#1
95 ram 2500 track bar replacement
I am in the middle of replacing my dodge ram trackbar.I have been spending the last few days replacing my dodge ram trackbar.I got the old one off, now I am trying to put on the new one.I have been trying to shimmy the new one in there with little success.does anyone have any advice on which side I should attach first? My thought is to connect the top end to the frame and then jack up the front of the frame to get the other side in.any advice is greatly appreciated.
#2
#3
Thanks for the very timely response.I was trying to keep one side attached and jacking it up, but it did not seem to be working.that was with the lower end connected though.it is very likely I just need the upper end connected.I will try it that way tommorow.thanks for the advice.Ill post my results later.
#4
#5
after spending a good hour playing with it i have gotten the crown nut on.does anyone know what the torque specs are for top and bottom?
---AutoMerged DoublePost---
well after looking around I can tell that there is no specified torque setting.I tightened it down and it works fine.thank you guys for the advice.
---AutoMerged DoublePost---
well after looking around I can tell that there is no specified torque setting.I tightened it down and it works fine.thank you guys for the advice.
Last edited by Mike H; 05-11-2011 at 08:41 PM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post