Is my Edge Juice w/Att dead or is it the PCM/ECM
#1
Is my Edge Juice w/Att dead or is it the PCM/ECM
Hello, Yes Im a newbee and need lots of help.
In September after having the Injector pump, PCM, ECM and heater plate replaced I just had to reinstall the Edge box for the guages only. I didnt want to connect the Inj pump tap wire just in case this pump have problems and I would have to take it back to the dealer and have them tell me the new warranty is voided.
When I reconnected the juice guages the only thing that would work was the PYRO and the FUEL PRESS displays. I figured it had something to do with the fact I didnt have the tap hooked up.
So now I have finally decided if its gonna blow its gonna blow and I wont be going back with a stock vp44 anyway if it does so I hooked the tap back up and it did NOTHING.
I still only have fuel press and pyro for monitor and NO additional power regardless of level.
So my question: Is my EDGE Juice w/Attitude DOA or could it be something else, PCM or ECM???
In September after having the Injector pump, PCM, ECM and heater plate replaced I just had to reinstall the Edge box for the guages only. I didnt want to connect the Inj pump tap wire just in case this pump have problems and I would have to take it back to the dealer and have them tell me the new warranty is voided.
When I reconnected the juice guages the only thing that would work was the PYRO and the FUEL PRESS displays. I figured it had something to do with the fact I didnt have the tap hooked up.
So now I have finally decided if its gonna blow its gonna blow and I wont be going back with a stock vp44 anyway if it does so I hooked the tap back up and it did NOTHING.
I still only have fuel press and pyro for monitor and NO additional power regardless of level.
So my question: Is my EDGE Juice w/Attitude DOA or could it be something else, PCM or ECM???
#4
I just went out to check for codes and there are none.
If my MAP sensor was bad would the truck still run???
#6
#7
You don't have it plugged into the MAP sensor do you? That is where it gets its power levels from, that is where the warranty will be voided. The Edge gets its gauge readings from the OBDII port under the dash, not the MAP. When I initially had a problem with my edge, I unhooked the map sensor, and my problem went away, and I still had all the gauges.
#8
You don't have it plugged into the MAP sensor do you? That is where it gets its power levels from, that is where the warranty will be voided. The Edge gets its gauge readings from the OBDII port under the dash, not the MAP. When I initially had a problem with my edge, I unhooked the map sensor, and my problem went away, and I still had all the gauges.
Thread
Thread Starter
Forum
Replies
Last Post
cass_epp
Wanted To Buy (WTB) - Used
6
03-20-2017 04:07 AM
stewart.william.c
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
02-11-2015 01:39 AM
Ram700
5.9 Liter CR Dodge Cummins 03-07
2
01-02-2015 08:14 PM