I'm matting an om 617 with an 2wd ax15 using koch adapters then its going into my 2wd 97 sonoma i was wonder if any one knows what rear axle ratio works well with this trans motor combo. i dont really haul much its just my driver and i would like to be able to cruise on the interstate comfortably. also any reviews on the ax 15 adapters and hows the motortrans combo workin for ya. thanks

 

373's are working the best for me so far had 342's and 410's in it and like the 373's worked best. (for me)
Deck60 told you wrong tire size 235/55/16 not 215.
Looks like I am going to have to pull the trans back out I think my slave cylinder going bad
Does not wont to release the clutch right hard to get into gear
Vette

 

I thought I send some pictures of the end results.
Vette

 

truck looks awesome not trying to ask for to much but could you cend some picks of ps,ac brackets and motor mounts also how far is the oil filter housing from the booster on you truck.

 

Well I am going to have to relocate the oil filter housing went in the truck fine but can not get to top off. As far as mounts here are some pictures.Do have the best picture of the power steering mount but it is off a 96 trooper and made the brackets. Deck60 is building the same thing as me so from his help and mine ask all the ? you need to.
every one here has been very helpful to me. Vette

 

Nice looking truck! You did a great job, looks factory!

 

thanks for the info the truck looks awesome you really did a nice job and it looks well planned. as for the oilfilter could i just tilt the motor alittle bit more twards the right. also did you have to make a oil pan relocator like heavy foot did. again great job on the truck looks factory.
REDNECKVETTE

 

If I had tiled it I would have a little problem with my exhaust not saying you could not work around that, I just wont it to lot right to me (just my way..)
As far has to oil pan I did not do anything to it but it is chose.
Vette

 

Really nice looking, do you remember what ac compressor number that is or was it from your truck originally?

 

It was a sanden aftermarket it is a universe type with fitting pointing up and turned it to the side for more hood room when I turned them up they hit the hood. I will say the A/C will frost the windows!!! I had the line made and charged it up and good to go. Add a picture on next post of the comp.
Vette