Ok got it started yesterday I got my front clip off today I got the old 5.7 out and everything cleaned up I'm ready to start putting in the motor tomorrow I'm taking pics as I go I just not sure yet how to put them up on here from my iPhone so I will start pics up asap I hope every one enjoys my swap

 

Sounds good. Lets see them pics!

 

Today I set the motor in and figured out what I'm doing for motor mount and the cross member now I got the motor back out so I can fab up my cross member in the morning I'm gonna get on a computer here in a little bit and get some pics up

 

sounds good. you using 1st gen isolators?

 

no im not they are to small for my taste so i found some today and started making my mount they are from a late 80s ford 460 big block, i am about to load the pics right now

 

here is some pics of my progress so far

 

I had my buddy put up some of my pics for me tonight but if u look in my pic u will see how much smaller the stock 1st gen isolators compared to the big block ford btw the stock 1st gen one in the pic is tore

 

Today I made my new cross member it's turned out pretty good I will get more pics up in the morning for everyone to see

 

here are the pics

 

Sweet!!! Got my cummins in motor mounts are made just got to clean them up a little bit for paint also today made my tranny cross member just got to clean that up too for paint but I will do both when I take the motor back out I also started putting in my transfercase but still have my crossmember to make for that I should be able to fit 5" exhaust if I wanted to so my clearance and drive line angles are working out with running a devorced transfercase I will get up more pics asap