Got motor mounts cut down ready to go....:jump:

no my trany is a 518 2wd going to my divorced tranfercase uses a short drive shaft

You should be able to have a driveshaft shop make you a custom unit. Or they might be able to suggest where to find a large yoke. You can also check the internet for shops that specialize in rock crawlers. They usually have a good line on custom yokes and such.

Well I kinda fixed my trans prob.. got me. Free eaton fuller 10 speed and a sae 2... so I will put it in for the fun of it:yeah:

Can someone tell me a good place to find another sae# 2

Been getting lots done i need to post some pics for you guys

These are just the pics i took the day i took it out of the dodge. I just set it on the chevy frame to move it all to the shop...The miller sticker is some free stuff i get from running a bar

:jump::hellox::yeah:

Got a lot done still have not made my mind up on a trans... Anyone have any input??:humm:

Standard or auto?

If standard, do an NV4500, it'll bolt right up you'll just have to get the driveshaft stuff done.
Auto...... maybe a 47RH or comparable Dodge tranny? Not sure on that one.