'97 F350 4x4 Crew '97 12V P-Pump & G56 Build thread
#21
Progress has been slow - a little here & a little there during Jan & Feb.
Pulled DIRTY carpets & pressure washed (freeze dried!!) Major improvement. Installed dynamat knockoff in floorboards.
Finished up lots of little stuff, cleaned up wiring harness, ran wiring for new headlights & led running lights. Installed internal regulator in alternator & an 'R' post to run my tach. Did some plastic 'welding' with my soldering iron to fix a crack in my header panel behind the grille.
Removed rear fuel tank & sold it. Scored a Bronco (35 gal) rear tank & brackets. Swapped in fuel selector valve & wiring from a diesel, prepped for an Airdog (eventually). Also began installing B&W gooseneck hitch under the bed.
Wired in heater grids to switch in cab & ignition switch. Built new IC tubes. Began planning for downpipe, exhaust brake, etc.
Got mockups for front & rear bumpers, but haven't begun fab work yet.
Pulled DIRTY carpets & pressure washed (freeze dried!!) Major improvement. Installed dynamat knockoff in floorboards.
Finished up lots of little stuff, cleaned up wiring harness, ran wiring for new headlights & led running lights. Installed internal regulator in alternator & an 'R' post to run my tach. Did some plastic 'welding' with my soldering iron to fix a crack in my header panel behind the grille.
Removed rear fuel tank & sold it. Scored a Bronco (35 gal) rear tank & brackets. Swapped in fuel selector valve & wiring from a diesel, prepped for an Airdog (eventually). Also began installing B&W gooseneck hitch under the bed.
Wired in heater grids to switch in cab & ignition switch. Built new IC tubes. Began planning for downpipe, exhaust brake, etc.
Got mockups for front & rear bumpers, but haven't begun fab work yet.
Thread
Thread Starter
Forum
Replies
Last Post
Gm3500
Chevy/GMC 6.2L and 6.5L
9
05-07-2015 11:01 AM