05' Nissan Titan 5.9 Cummins
 

Here is a never ending project!! I have already done an SAS conversion on this truck with a 4-link front suspension and 14" coilovers, and 41" Iroks. Now I am lowering it a bit on 38's and installing a 97' 12V, NV4500, and NP241DHD. Here are a few pics.
Oh here are a few of my sponsors that have helped me out tremendously with this conversion!!! Thanks guys!

Nitto- 38" Mud Grappler's
AEM- Intake
Zoom Performance- Stage II VT performance clutch, flywheel, and hydraulics
Looking for a good set of injectors!


Also Installed the TST KDP Kit, Fuel Plate
5" Full Spectrum Exhaust
Ford Dana 60 front High Pinion and Sterling 10.5 rear axle.

Still have a lot to do before installing the Cummins...
Attachment 47625
Attachment 47626
Attachment 47627
Attachment 47628

Hellz yeah!!! :rocking:

Thanks to the guys at Diesel Plus I finished up my parts list today! They had my S300G, and Bosch 370HP Non-Marine Injectors!

Sorry guys,
Here is an update. Finally got the moter in for a test fit. Now it is back out for the new seals and gaskets.
Attachment 47326
Attachment 47327
Attachment 47328
Attachment 47329
Attachment 47330
Attachment 47331

---AutoMerged DoublePost---

Well as I was replacing seals and gasket, looks like I was too late to install the KDP kit!! But the damage was minimal the aluminum gear cover is cracked and will need to be taken off and welded, minor set back. but installed my Zoom VT stage II clutch kit today. It looks like it is going to grip! I will have the motor and tranny mated tomorrow, and if I get the cover back on in time I will have the motor back in the truck for good. Then we can get the motor mounts mocked up.
Attachment 47332
Attachment 47333
http://i406.photobucket.com/albums/p...k/IMG_2722.jpg
Attachment 47334

That is an awesome project.:pca1:

:pca1::tu:

u took a bad ass looking truck and made it ten times better and its not even done keep it up :tu:

effin awesome... i have a frontier and would like to do the same, ill probably need a 4bt or a ud motor though

Thanks guys,
I had to get the timing cover back on replace all the seals and gaskets before I put it back in. I will have it back in the truck for good on a few days, and I will update with some pics.

Nice lookin truck. Although that clutch doesn't look like it will hold much more than stock power, not a lot there.