More air equals lower temps with a diesel.

One of my twins went bad, so I pulled that setup, and I'm now running the same turbo as FTE. The only time that I need to keep an eye on the heat is under 1800RPM. The turbo doesn't get into the efficiency zone on mine until a bit over 2000RPM. I'm working on a setup to address that.

 

Hey RED, have you tried that larger I/C yet?

 

No, it's going to require all new I/C plumbing. I'm replacing my radiator next weekend, so I might get to it then.

 

What is the weight of a Kubota V2203 dry? What is the weight after all of the accessory brackets have been installed? I am wondering if this would be an option is something a little more aerodynamic like an F Body Camaro or even a Vette?

Sent from my DROID RAZR using Tapatalk

 

I didn't weigh it but I did take a before and after ride height and it wasn't any different than the 2.3 4cyl that it replaced.

 

I am still in planning and locating a good motor cheap. But I was thinking a 240z my brother has 3 of them sitting at my parents house

 

Welcome to Diesel Bombers.

But it would be nice if you would go here and Introduce yourself. Diesel Bombers Introduction - Diesel Bombers

Then pay attention to what the thread is about and post helpful information or ask a question.

Otherwise please by all means start a new thread.

Thank You and enjoy the forum.

 

I think the advertised weight from Kubota is 396lbs. I think that is alternator only. NOT the Carrier configuration. And that is the newest model year. I will have a weight on mine in the next day or two I will let you all know

 

I like that idea, DO it!

 

I am still very curious of your findings.

Sent from my DROID RAZR using Tapatalk