just installed airdog 150 and truck has no power
#11
i checked all the lines to the connector tubes and I had one loose. It was the number 4 cyl. Also the connector tube nuts were all loose and I got almost 3/4 of a turn on all of them. That was torquing them down to 40ftlbs. I have to put the valve cover and fuel rail back on and I will fire it to see if that helped the problem I am having. Do you guys think I should take the exhaust rockers off and check all the hold down bolts for the injectors. I did all of them to 89inlbs. Hopefully that will work and these problems that I just fixed are the problems. Do you guys think that all these things would cause my problems I am having. Thanks for any info. PS i also did the exhaust rockers to .020, but Iseen the valve cover says .026. Will that make that much difference.
#12
Hi guys I went threw everything that I did and I found that the connector tube nuts were to loose and the number 4 fuel line was loose. I pulled the injectors and re tightened all of it and put it all back together and it is running good now. i have no codes and it doesnt die out when it warms up. All in all I rerouted the return line on the airdog and just went threw it all. Thanks for all the help narrowing down the problem and asking the right questions to make me realize the mix up I had going on. Thanks again!!