2004.5 dodge 6speed cranks wont start
#1
2004.5 dodge 6speed cranks wont start
After driving my truck all weekend putting over 400miles on it, i was on the trip home when an hour into the drive the truck skipped, then sputterd and the engine light came on, i drove about 20 minutes to get through boston, i could not go over 2000rpm without a sputter and loss of power. it seemed to start getting better and come out of it when it sputterd from 55 to 30 and i pulled it over and it stalled, i checked for leaks, fuel filter was clean. i have a half tank that was treated when i fueled it with the power service. but now the truck will not start! it just cranks over. Im going to get the codes tomorrow around noon. just want to get this out here so i can get some ideas of what this might be. the trucks only got 53000 on it and has a straight pipe and airaid intake, as far as i know there has never been a tune on it and its stock! please help i need this truck for tuesday!!!!!!!!!!!!
#4
ya, im going to pull the codes around lunch time, im hopeing for that, seems strange to me that it went with so little miles, my 12 valve has 14000 with no issues stock lift pump pushing way more fuel than stock
#6
PO628 -Low vlotage at the lift pump
PO148- High PSI Common rail checksum
PO107- inlet air temp low
PO73- ambient temp sensore to high
PO88- fuel psi to high
These are the codes, i had it towed to the dealer, for it to be fixed under warrenty. the lift pump is back ordered.......so i was thinking about a fass or air dog.
PO148- High PSI Common rail checksum
PO107- inlet air temp low
PO73- ambient temp sensore to high
PO88- fuel psi to high
These are the codes, i had it towed to the dealer, for it to be fixed under warrenty. the lift pump is back ordered.......so i was thinking about a fass or air dog.
Thread
Thread Starter
Forum
Replies
Last Post
Mac1997
24 Valve 2nd Gen Dodge Cummins 98.5-02
2
07-13-2015 05:08 AM
Strangeak
Diesel In Distress - Support Ticket
6
06-19-2015 11:07 AM