If the sensor screws in, a little teflon tape, or a little bit of black silicone (the oil resistant stuff).


But were glad you got it running!! Wow, it's been quite a while, eh??

 

Hi WildBill, yes, been a long time.... been on tha road a bit doin that music thang

As luck would have it, the water sensor is "flat with clip & o ring" type that you have to pry out with a lil screwdriver, pretty much making it impossible to clean up and re-install.
Would be nice to just be able to replace the clip & o ring, but you pretty much crack & destroy the sensor itself just removing it.....GPM

 

Other than that, sounds like your good to go!!! I will close this thread back down, and wish you the best of luck on your career.