thanks, sounds like a right good point of view. i agree.

 

Dr. G here, and no I'm not a real Dr. its just a nickname I picked up when I raced boats and built race engines for them. I don't do that anymore but the handle stuck for some reason. I still work on boats, motor cycles, 4 wheelers and almost anything that runs on gas. I quit working on cars and trucks (except my own) because at 70 yrs. I don't fit in small places as easily as I used to. Anyway, I have a 2008 F-250 crew cab with LWB. and the 6.4 PS diesel.
I do all my own service work on it and avoid repair shops and dealer shops like the plague. I just turned 80K miles on it and would like to share my experiences and problems with this vehicle. So I'm here and off to the technical question and answer section to learn and share.
Thank you
Dr. G.

 

Hey all!
This is my first post, ever!! Forgive the many blunders to follow!


Question, I have a 90 F250 4x4 Diesel with the E4od. Hoping to swap in a 5 speed from a 88 F250 2x4 Diesel donor truck. Would this be a straight swap/interchange? Any advice?

 

Both F250's have the 7.3NA

 

Sounds like some hella good advise, thank you!

 

I have been a diesel person for a long while. I have been out of sortes for a while. I have a 94, 05 Cummins. And I have drove Big Trucks over the road for a while. Sence I have been out of touch with the tech things for a a while.

 

wow don't no where this is going to end up 2002 duramax single cab 5" spindle lift air bags in the rear on 17's with 285's stock motor, nice introduction . I have computer skills of a 8 year old so I thought this was where you set up your sig thanks POZR-MECH. Part of the bad head Gasket club.

 

old thread but new to me exhaust gases in the coolant res hard upper radiator hose 100500 miles would like to no if erg could cause exhaust gases in coolant, or cup seals would allow water to enter oil. from all info seems like head gasket fresh oil fresh coolant. went to change thermostat low and behold there were none and the coolant sensor was looped with a wire. red flag 4 me. need good pitctures for head gasket removal.

 

my english is like hell anyhow its good to me to try new people with a lot of knowledge and a hight sense of humor

 

New to the site.. need help with P0106 code on 2007 6.7 cummins.. any ideas?