DTC P0236
#1
DTC P0236
Well I finally got my stalling issues solved..... new relocated pmd, OP sensor, new fuel lines, ect.... Got it all buttoned up and truck started up beautiful. Ran great took it down the road, and the check engine light popped on. Pulled the code and got PO236. Turbo/super boost sensor a ckt range. Checlked around under the hood, and dont see any broke vaccum lines, and every thing is hooked back up... Any ideas where to start on this issue....
Thanks in advance for all of the help
Thanks in advance for all of the help
#2
#3
well i went and bought a vac gauge. Checked at the turbo with the engine idling.... didnt move off of 0...... Went and checked the sol on both sides... still nothing. Sol seems to be working, as i took it off and sprayed wd-40 in it and when it was back together i can here it clicking... continued following the vac hose down to the the side of the engine... Looks like a barbed fitting. Checked here as welll... Nada Time for a new vac pump????...
Thanks in advace
Thanks in advace
#8
you can make own TM it lot cheaper
Make Your Own Mechanical Wastegate Controller
i just made one it only cost me 0.39 cent with taxs all needed to get was the spring and went to Ace and got #49 spring and didn't add any thread to J hook i just shorting it to fit and drill little hold for washer and cotter pin so won't fall out turbo arm
Make Your Own Mechanical Wastegate Controller
i just made one it only cost me 0.39 cent with taxs all needed to get was the spring and went to Ace and got #49 spring and didn't add any thread to J hook i just shorting it to fit and drill little hold for washer and cotter pin so won't fall out turbo arm
Thread
Thread Starter
Forum
Replies
Last Post
jman2222
24 Valve 2nd Gen Dodge Cummins 98.5-02
5
04-25-2016 07:45 AM