1996 6.5td idle problems
#13
#14
Join Date: Oct 2012
Location: Scugog Island ONT.
Posts: 1,848
Likes: 0
Received 103 Likes
on
103 Posts
Go through this diagnostic:
www.AccurateDiesel.com - PMD Installation Instructions - Accurate Technical Services, LLC
www.AccurateDiesel.com - PMD Installation Instructions - Accurate Technical Services, LLC
The following users liked this post:
Irish_Alley (09-24-2013)
#16
ok tested the new pmd all went good till the last step between "B" and "F" supposed to get a ac reading of .8-1.0 we got .2. just for ***** and giggles I put the old melted pmd box in just to see what she was reading. very first rotation of the crank she wanted to fire up. so we got her started and she went back to the surging idle she will go to 900 with a touch of white/gray smoke then up to 2k with black smoke. so we might try to borrow someone's pmd and see what she does then
---AutoMerged DoublePost---
OK now I'm confused (don't take much) but before calling about receiving a bad pmd I put the new one back in to try and test the f and b post. Well she started up and idled at 800-900 rpms still smoked a little but it was more gray. Went to see if she will rev up it went to 1k and wouldn't go any higher would start to miss and blow more smoke. Shut it off and restarted it only to have her idle at 400. But on my tester I wasn't getting any reading while cranking (B&F)
---AutoMerged DoublePost---
OK now I'm confused (don't take much) but before calling about receiving a bad pmd I put the new one back in to try and test the f and b post. Well she started up and idled at 800-900 rpms still smoked a little but it was more gray. Went to see if she will rev up it went to 1k and wouldn't go any higher would start to miss and blow more smoke. Shut it off and restarted it only to have her idle at 400. But on my tester I wasn't getting any reading while cranking (B&F)
Last edited by Irish_Alley; 09-25-2013 at 02:02 PM. Reason: Automerged Doublepost
#18
its not black now, more like gray. the black was from the surging idle at the high point (old pmd) the new pmd is now just gray smoke and wont clear up, wondering if some of the injectors arnt spraying like they should? which sucks cause due to the rust i dont think they will come out easy or in one piece
---AutoMerged DoublePost---
also i dont think i have a cat didnt see one when replacing starter but i wasnt looking for one but i know theres no egr
---AutoMerged DoublePost---
also i dont think i have a cat didnt see one when replacing starter but i wasnt looking for one but i know theres no egr
Last edited by Irish_Alley; 09-26-2013 at 05:38 AM. Reason: Automerged Doublepost