hey i'm pulling the engine out of my 94 2500 6.5 TD and wondering on what's the best way to do it and any tips to be offered

 

Take lots of pictures, use lots of light and try to put as many bolts and nuts back in place after removal, makes figuring out where everything goes a lot easier!

 

ya it's ready to come out other then motor mounts and im fighting with last 3 tranny bolts

 

Photos, ziplock bags and a labeler to identify everything.Make notes where the hangers for fuel lines and stuff go on the bell housing, also wire routing near the heat shield. I found a flexiblegear wrench worked best and fastest for those pia bolts along the firewall. Good luck.