This weekend I installed a TS Performance chip, on stock setting I have no power and the truck doesnt want to shift until i let off the pedal, On the 50Hp setting thought my truck runs amazing. Since i installed the chip my SES light comes on everytime i drive. I scaned for DTC's with autoenginutiy and got a list of about 20 codes, i dont have the list in front of me but the one i remember is P1316, only in stock setting do i get the loss of power symptoms associated with this code. The same list comes up no matter which setting im in and if i clear the codes they come back within a few minutes. Any ideas?

 

Did you make sure to remove ALL the silicone? I had issues with mine I ended u having to send mine back. But I had to keep removing mine and cleaning more because I never got it all and it would kill the motor whenever I switched settings.

Sent from my dumb phone!

 

I have not pulled it back out, but i made sure it was super clean before i installed it. I guess it wouldent hurt to pull it and check again. i can switch settings just fine the only ones i use are stock, high idle, anti theft and 50hp, i have have 100 and 140 but i dont want to run those on a stock tranny.

 

I ran them on my truck and trans never slipped once. Id try pulling it checking the contacts etc.

Sent from my dumb phone!

 

Sounds like its not burned for your PCM code...

 

if that is the case a reburn would fix that issue right?

 

Yes. You'd have to find a shop that does reburns, many sponsors here do them.

Sent from my dumb phone!

 

Yes, a reburn could fix it, however I cant tell you for sure that its not burned correctly, just sounds like it.

Where did you get it?

 

I got it from kens performance solutions. He is a great guy to work with so he is looking into it for me. i just figured the chip was the reasons for the codes, i will have to remove it when i get home from work and see what i can do about it. was hoping to have it this weekend for the trip up north

 

gauges?