Chip or PCM Issue
#1
Chip or PCM Issue
I'm going to throw this out there and see what you guys think the issue is here.
I had a TS Chip sent off and flashed with PHP Tunes. My truck is a 99 6spd with PCM code DAC2. I can tell by the power the truck makes that the PCM has some type of current tune loaded but I don't have the tuner to know what it is or whos tunes.
Once I installed the 6pos Chip the truck has less power. No Code still runs smooth just no low end power and very little throttle response. I'm trying to figure out if I have a bad chip or bad PCM.
Luke
I had a TS Chip sent off and flashed with PHP Tunes. My truck is a 99 6spd with PCM code DAC2. I can tell by the power the truck makes that the PCM has some type of current tune loaded but I don't have the tuner to know what it is or whos tunes.
Once I installed the 6pos Chip the truck has less power. No Code still runs smooth just no low end power and very little throttle response. I'm trying to figure out if I have a bad chip or bad PCM.
Luke
#2
Honestly, if you just want to pay $200 and be completely done with it, I'd take it up to ford and just have it wiped and flashed, make it like it just rolled off the lot as far as the pcm firmware.
That way you won't be wondering and you can start from a blank canvas. I've heard bully dog programmers almost leave like a lock on it even when you put it back to stock so you can only use your bully dog back on it again.
That way you won't be wondering and you can start from a blank canvas. I've heard bully dog programmers almost leave like a lock on it even when you put it back to stock so you can only use your bully dog back on it again.
#3
#5
Thread
Thread Starter
Forum
Replies
Last Post
Jet A Fuel
6.7 Liter Dodge Cummins 07.5-12
3
08-03-2015 10:45 AM
Dan S
24 Valve 2nd Gen Dodge Cummins 98.5-02
4
06-09-2015 06:55 PM