Solid Motor and Tranny Mounts?
#2
#3
well ya see my problem is i put a new tranny mount on my truck few months ago because the driveshift was hitting the floor but it didnt help and my motor is moving so much that the belt is hitting the radiator hose and rubbing a hole in it so i put new motor mounts on the tuck and it still rubs and the driveshaft still hits...i have a banks trans command and a ts 6 position chip and a six in lift but the driftshft isnt at that steep of an angle and the driveshaft only hits when i get on it and it shifts
#5
#7
#9
i know for sure... you can see the spot on the floor where its hittin
---AutoMerged DoublePost---
i can sit under the truck and push up on the tranny with my hands and i can move it a little bit but its just the rubber in the tranny mounts flexing nut i just replaced the tranny mount but it feels like i can move it more than i should be able to
---AutoMerged DoublePost---
i can sit under the truck and push up on the tranny with my hands and i can move it a little bit but its just the rubber in the tranny mounts flexing nut i just replaced the tranny mount but it feels like i can move it more than i should be able to
Last edited by bigstroke7.3; 05-25-2010 at 11:17 PM. Reason: Automerged Doublepost