I am in need of a turbo and I finally found one. A local guy has a h2e turbo and up pipes for a 2002 that I can pretty much steal from the guy. Will this turbo and up pipes work on my obs? What else will I need and about how much $ we talking?

 

If its for an obs and its just uppipes and turbo. you might need a drivers side manifold, pedestal, oil feed and drain lines, intercooler set up or a delete pipe and a down pipe. Is it just a stock H2E and who built the pipes?

 

He said its a modded h2e off of a 2002 that they guy before him was going to make a pulling truck so im assuming the guy before this guy built them, said the guy was a welder and fabricator. So in the case it is of a 2002 will the turbo its self work on a obs 1995? Will the up pipes be any good or should I toss them and get obs bellowed up pipes? And how much can a bet a block off pipe?

 

The turbo can work on anything if you have the fuel to spool it. The pipes can be used, I have heard SD pipes can be used in an obs with no changes and I have also heard you have to swap manifold

 

Will I have to buy a new pedestal to make it work? And I have stage 2 injectors. If I am buying just a bar bone turbo what would I all need? Like up pipes, pedestal, oil lines?

 

If it doesn't come with a pedestal you will need one, stage 2s should be enough to spool it but I don't know. I kit that you buy comes with uppipes, pedestal, oil lines at a minimum. Then some come with a Y pipe, clamps and boots

 

This is a t-4 turbo correct? So I would need something like the irate kit?

 

The H2E is a T4i, I'm not sure if irate makes a T4i kit or not but you need someone's kit