Third time's a charm??
#1
Third time's a charm??
So, this is the third time I've made this post in 3 forums now. It's been made in FTE, Diesel Bombs general IDI category and now I'm here. Hope someone can toss out some input. My IP is leaking from just below the torque screw. It's coming from the fitting under the red plastic cover shown in the pics. From what I have researched, it's the guide stud which holds down the metering valve assembly?? I'm sure there's a seal on the guide shaft but from what I can see in the stanadyne drawing, you can't pull the guide stud without things coming apart on the inside. I guess my question is, can I pull the guide stud and try to re-seal or is it holding a bunch of other parts in place, that will come apart if I take the guide stud out? Just want to fix this damn leak. My main feed line from the filter was leaking also and I bought the braided stainless one from Mel and that problem was solved but this one is worrying me. Any input would be great. Thanks in advance.
#2
#3
#6
seemed to just be an adjuster, but could not get mine to budge what so ever.
---AutoMerged DoublePost---
After looking through everything I could find, it's a discharge fitting, which is help in place by a stud guide, and looking behind it within the pump, it seems to be going through the governor spring, and hold it in place. I could be wrong though, someone else should chime in soon.
---AutoMerged DoublePost---
After looking through everything I could find, it's a discharge fitting, which is help in place by a stud guide, and looking behind it within the pump, it seems to be going through the governor spring, and hold it in place. I could be wrong though, someone else should chime in soon.
Last edited by Dortiz; 12-03-2013 at 12:55 PM. Reason: Automerged Doublepost
#7