Does anyone know the specs on POD's? Also, anyone who runs them in their truck how do you like em? They are fairly cheap so that kind of worries me. Thanks for any info.

 

JB6801127 4x0.015" 160° cone angle.

 

I would not waste money on the for a non-I/Ced truck... Not much bigger then stock. I would think hard about it unless they were real cheap for a I/Ced truck too.

You stocker should carry you to 350hp as long as they are not shot.

 

Thanks alot guys! Maybe one of these days I'll give in and buy a set of SDX's.

 

160* angle? Is that what makes them smokier and a little on the warmer side?

 

Smokem, are these numbers the same for the (intercooled also) I have pod's and I am looking at some sdx 5x14 but these don't appear to be much bigger (im sure they they are better though).

 

Non I/C DSLA155 P104 4x0.014" 155° cone angle

Intercooled DSLA145 P265 6x0.010" 145° cone angle

 

i run the equivelent of a pod there made by trinity injector works and there a little bigger and better quality about the same in price butt i love mine i have virtualy no smoke unless i make her do it!!! butt anyone can do that perfect power increase for my truck beem running them for a while now and i never have problems with emm lots of guys on here swear by sdx butt over all im impressed with them

 

i run PODs and i love them. alot of guys say they are dirty and run hot but i dont think they are too bad. they haze a little but nothing too carried away. i know there are better injectors but i am happy with mine. thats just my opinion

 

i agree. mine have a little bit of haze but nothing to complain about. didnt hurt fuel milage either so that was a big plus for me. egts are fine too.