Thanks 1GENFARMBOY Who made your intake horn? Is your intake manifold from a 94 to 98. If it flows better goog but it just looks good.

 

Tim Worline made my stuff, very nice high quality, i did a P.S intercooler the cooler tubes and a 60mm turbo upgrade at the same time, before my EGT's were through the roof flyin by 1600* before i got to 75mph, after the parts install 1250* is max no mater what i'm doing, drag racin, pullin a 16,000lb goosneck up a long hill, or what ever, so to me those three things were the difference in my truck beeing useable or just another mode of transportation.

Darwin

 

Man, that is what I should be shooting for with my engine right thar!

 

Anybody have any before and after dyno #s from an intake? What do you guys consider not huge gain? I'm building one for my 91 non I/C with 3" exhaust pipe, would like to think it will do some good. If it can give me 10hp I would be happy.

 

M & H Inc. - Air Intakes

 

Just a comparison between stock on my 91 non I/C and the 3" inlet I'm building, stock is approximately 3.5 square inches and the 3" is 6.5 square inches.

 

Sweet Dude!

 

The finished product, complete with ugly welds:

 

Found this.

Banks Twin RAM Intake Manifold 1994 1998 Dodge RAM 5 9L Cummins Non EGR 42710 | eBay

---AutoMerged DoublePost---

Prolly what I'll be getting or making.

 

The 24v intake horn works aslo. The only thing with it, is that I had to get 2 longer bolts for where it goes on the engine. I'm very happy with the difference it made. You will be able to feel like the engine is running easier. Aslo removed it coils from the grid heater.