Tell me when I buy these gauges what exactly do I need to install them. I want the full detail. What tubing, wiring, NPT adapters? The whole deal. I need to know if anyone has a full list. To get the job done in one fail swoop.

 

Contact a vendor. They put the stuff in all the time so they can probably hook you up with all the things required to plumb, wire and hook up your gauges.

 

usually all the needed parts come with the guauges except the wiring to wire in the light bulbs, if they do not come with the guage, then there will be a kit that you can order for the guage to have everything included, just depends on the brand of guages. But there is also different things you can order to make the install easier like, a boost bolt, and different tranny temp senders, the biggest part on installing guauges is drilling and tapping the exhaust manifold, it seems like it would be a simple job, but plenty of people mess it up real bad, and everyone has there own way of doing it.

 

Go to [url=http://www.genoesgarage.com] 1 800 755 1715 ask them they are very good at helping every one. I have the pillor triple mount. IF I had it to do over it would be the triple dash pod. This way you are not looking up and over to see your gauges lot easer to see. They have a good chose of gauges also === GOOD LUCK ===

 

I went through Geno's garage to get my Triple A-Pillar and I love the looks but if I had to do it over again I would have gone through Luke at Diesel Dawgs his ISSPRO Kit comes with everything you need wiring adapters and everything. The only thing that you might need to buy is the Tap for your egt probe With the kit from Genos I had to buy all the wiring for the lights and didn't include everything that I would have liked. So if it was me I would send Luke a PM!

 

We always include everything you need to complete the install.

 

Diesel manor also has a kit with everything you need. I only had to buy the drill bit and tap for the pyro, but they sell that also