I just recently installed my front diff cover and just noticed after my test run and fluid check.That the bracket that hold the steering stablizer just barely rubbed the diff cover.I was going to cut the bolts 1/4 inch and trim the plate.I cannot turn the bracket at all. Did anyone run into this problem?Or any different suggestions would be appreticed.

 

What truck?

 

the one in my sig?

 

No front lift or leveling kit?

 

No not yet waiting for my kore hp series leveling kit to come in.I did trim the bolts and the plate but at full lock it is scary close.I do have the updated 2 peice steering rod and track bar.Now that i am going to put on a leveling kit should there be any problems?I do plan buying aftermarket steering stablizer to replace the stocker any suggestions?