Holset Turbo... HELP!
#1
#3
I got a question about my turbo. Its a holset that I bought off ebay. THe guy said it was a hx30. The holsets i have seen hava snap ring that holds the compressor housing on. Mine has a few metal bar type things that hold it on with bolts. Does anyone know if I could replace the housing with the hx35 housing and wheels and use a snap ring instead
---AutoMerged DoublePost---
heres a pic to show you what I am talking about. It the cool side
---AutoMerged DoublePost---
heres a pic to show you what I am talking about. It the cool side
Last edited by geauxsimon; 11-17-2009 at 06:47 PM. Reason: Automerged Doublepost
#4
I got a question about my turbo. Its a holset that I bought off ebay. THe guy said it was a hx30. The holsets i have seen hava snap ring that holds the compressor housing on. Mine has a few metal bar type things that hold it on with bolts. Does anyone know if I could replace the housing with the hx35 housing and wheels and use a snap ring instead
#5
#6
hx40
hx40 would not be a good mesh with your he351. They flow almost the same and you would just be complicating your setup. I would suggest to decide how much boost you want- and get an appropriate turbo to reach that level. Also, the stock head gasket on the 2006 should be good to 40-50lbs of boost- above that need head studs. Remember the turbo is the most restrictive item on your whole engine - free up some flow and the dyno will become your friend.
Thread
Thread Starter
Forum
Replies
Last Post
avatardvr
Ford Powerstroke 03-07 6.0L
18
08-08-2019 12:38 AM
Cumminsfreak24
Dodge Truck and Cummins Turbo Diesel Forum
0
05-06-2015 04:56 PM