Edge comp on and now my truck stays at full throttle
 

i just installed an edge comp box and it drove fine at first i drove it about ten miles and my rpms started jumping then ten more miles the truck stays at full open throttle. any ideas?:argh:

Try removing the Edge Comp and see what happens. Determine if it is an Edge issue, or a truck issue. Any codes?

its not the edge. i disconnected it fully and it still did it i pull off the plastic cover off of the throttle cable assembly area and the top cable on the engine side is slack. no tension whats so ever. i traced it back to an assembly on the front underside of the driver side battery.

reset the APPS

turn key on but dont start
slowly fush throttle pedle to floor
slowly release throttle pedle up
turn key off
start truck and see what happens

also there was i think a small vacuum hose that came off of the assembly at the front underside of the drive battery that i broke messing around with trying to see what was happening. will the apps reset put tension back on the cable?

No, thats your cruise control vacuum pot.

no this is the electrical end only

ok so there is only tension on that cable when cruise is on. what about the vacuum hose that i broke playing with it. what does that do?

also the pedal isnt sticking and seems to be working fine. so would the edge have messed up the volts going through the apps?

the edge will have no relation at all to the APPS

ok so when we removed the whole triangle shaped throttle assembly (the black box on top of the vp) to get the wires on the pump to tap it for the edge, could we have stretched a cable or messed up the apps? or is that a fairly tough system