No codes and no emissions in west virginia.

 

Also check the ECM mine did that and it ended up being a bad ECM

 

check your connection from edge to the pump

 

Well guys, i bit the bullet and bought a new vp44 and installed it. It quit smokin like a train, quit shutting down on pull , but still surging on pull although not quite as bad.
The computer is actually off another truck, same year, engine, and transmission set up. The origninal went out back last winter, bought one form autocomputerexchange.com total pos. ran worse with the new computer. Then it would cut out about 25-30 mph.

Any other ideas guys? also, when I installed the edge nozzels a local diesel shop said with the 24 valve I did not need to pop test the injectors. Is that true? or should I get them tested and where near Eastern WV can I have them done

 

Yes you must pop test your injectors. If they told you that you didn't need to then I would stay away from their shop.

 

What problems would i have if they werent, and do you know of anywhere to have that done?

 

Well guys thanks for the info but thats the least of my worries now. Totalled her yesterday

 

Bum deal, What happened? I take it your alright at least

 

Well I hit a deer last week and I think it messed someting in the fronte end. got tight in the front end and wouldnt take a turn, shot it over 90' bank, wrapped her round a tree. thankfully I walked from her.

 

Damn dude.... glad your ok