Cummins 24 valve upgrades on the cheap?
#1
Cummins 24 valve upgrades on the cheap?
I recently completed a 1990 Ford F250 to 1998 24 valve cummins conversion. During the conversion I installed a 4" custom exhaust system, K&N cone air filter, and installed a 3" rolled tube intake assembly, installed waste gate ajustable tee assembly, Fass 150gph fuel system, 500HP clutch assembly, and a boost fooler assembly. The engine other than these mods is 100% stock. It gets up a goes just fine just want a little more upgrades on the cheap? Kinda blew my funds up to this point. I cant use any type of programmer as I lost the OBDII connector in the conversion of the truck. I still have the cummins electrical diagnoses plugs though. Is there a way to take my truck to a cummins shop and get changes made to the electronic system and such through these plugs to get more power similar to what a programmer would do plugged into the OBDII port? And is their any other mods on the cheap I am missing? Or am I sounding freakin stupid? Sorry I'm new to the forum and the cummins engine.
#3
the quad adrenaline does not hook into the obdII port it wires into the pump(spliced),map sensor(plugs), and one other plug(data link),the oil/trans temp(optional),and drill the manifold for the egt probe ,here is a link to the instruction booklet
http://www.quadzillapower.com/files/...98-02_6_09.pdf
Luke got to you before me and Luke is the guy to buy from too,very knowledgable
http://www.quadzillapower.com/files/...98-02_6_09.pdf
Luke got to you before me and Luke is the guy to buy from too,very knowledgable
Last edited by yj junker; 10-27-2010 at 12:04 PM.
The following users liked this post:
snm76 (10-28-2010)
#7
#8
HAHA let me explain, bought a truck with no engine, puller motor in the plans, but in the meantime, if it wasnt too hard of a job i would like to plant the 24V that i have sitting on my shop floor till the new 12V was ready.
#9
The following users liked this post:
connermcpherson (03-08-2011)