where is everyone referencing fuel from after installing the aird dog 150? right now get fuel pressure from the schader valve on the stock fuel line at the vp44.

 

I think most people get it right off the supply line Banjo bolt. It's the closest to the VP44 you can take the pressure.

 

X2

 

does that banjo bolt come with the AD150 kit? or if not where can i get one?

---AutoMerged DoublePost---

bump

 

Here is the one I was telling you about earlier.

push lock

 

exellent! then i would need a union to for that to screw into the vp44 right?

 

not quite - the fuel pressure reference comes from the 1/8" npt port on that 90. And you should already have the fitting to go into the VP-44.

 

I know the fuel pressure comes from the 1/8" port. I was referring to how to connect that fittiing to the vp44. Im pretty sure the current fitting on there is a banjo bolt.

---AutoMerged DoublePost---

would this ben the one i need to connect between the vp44 and the 90* 1/2 fitting?
http://www.vulcanperformance.com/1-4...-p/08orb08.htm

 

This is what you want:
BANJO BOLT - TAPPED ('98.5-'09, 5.9L & 6.7L) DODGE-Dodge Cummins Diesel Truck Accessories Geno? Garage
Then thread your pressure sensor into it.

 

you do know that i am getting an AD150 right. if i get the AD i will have to use a JIC 90* fitting to go into the vp therefore i wont need the banjo bolt right?