Stack Installation
#1
Stack Installation
Hey guys i just ordered my stack kit (Thanks Luke, Diesel Dawgs) and will be putting it on the truck in a week or two. Its all 5 inch pipes and dual 6 inch stacks. Is there any advice out there to make this installation go smoothly? it doesnt seem like it will be to hard. i have a bedliner, will there be any problems with it? thanks guys
The following users liked this post:
Diesel Dawgs Performance (07-05-2010)
#2
#3
#4
Get a couple of friends to help, an air body saw helps, leave the protective wrap on the stacks as long as possible, do not slide anything against them, make sure they are CLEAN before start up, measure, measure, measure, be sure you can get the truck out of the garage afterward, before you mount them solid get far enough away so you can see if they are plumb and square and straight.
Thread
Thread Starter
Forum
Replies
Last Post
Jet A Fuel
Tech Article Submission
0
06-05-2015 03:28 PM
jrsavoie
Chevy/GMC 6.2L and 6.5L
1
02-06-2015 09:44 PM
ramrunner01
24 Valve 2nd Gen Dodge Cummins 98.5-02
3
01-19-2015 05:01 PM