ok i have a mechanical autometer fuel pis gauge in my pillar pod can some one make a list of parts sizes and types of stuff i will need to hook it up Ie.size type hose fittings and everything basicly thanks for any one that can help

 

Auto Meter maybe this will give you an idea of what you need

 

I can get ya a package together.

 

PM me a price

 

I am uncertain what kind of fuel filter housing a 98 has but I believe it should be very similar to a 99.

Here is an install on a 99 CTD:





So, basically what you need is a fitting to thread into the filter housing (this is a 1/8" npt fitting), and a needle valve, some line (1/8" DOT approved air brake line), and a guage. Obviously, if you use 1/8" line you need 1/8" npt fittings. Also, the fitting at the gauge should be 1/8" npt female. I would also push the 1/8" tubing through larger 1/4" tubing where it passes through the firewall for abrasion resisitance.

I cant give you exact part numbers but it should be too hard to track down the parts. You dont really need to buy a "kit" for this.

 

Since your running the raptor 150 id recommend our Vulcan Filter to Injection Pump Kit. This will replace everything from the Filter to the VP44 and give you 1/2 or 3/8 line for better flow. It will also include the tapped 90 degree fitting for fuel pressure access. This is a bit more expensive but will net you a few more pounds of fuel pressure.

 

I did not even see that Luke - good catch.

 

The only reason I say this is these are very popular with the guys running the Raptors, HPFP or the home brew lift pump setups. Theres quiet a bit of restriction on the stock setup.

 

ok thanks guys helps out alot and i will have to wait to save some money for what you had mintioned luke but i will deff. hit you up so i can get rid of that stock filter

 

got my fuel tubing kit form Jegs racing and all the connector and fittings are in the tubing
kit. 4AN size