tapping my pump?
#12
#13
#14
Thats a pretty cool fact... I didn't see that in the manual... Is that through timing adjustment alone then? By connecting it to the CAN connector only?
#15
so i got a question!! if i dont tap the pump wire on my quadzilla adr. can i rum my smarty on sw#9 timing added and not mess up anything?. or is it better to tap the pump withn the quadzilla and leave the smarty on a no added timing sw#
#16
Not tapping the pump on the ADR causes it to be ONLY timing is what i assume. So not tapping AND running Smarty WITH timing is a bad idea. If your going to stack for mega power just throw the idea of an everlasting VP out the window. I would assume the smarty adds fuel just as any other tuner would... It just does it by reprogramming.
If i were you id tap the pump for the ADR and run smarty with no timing. With the money you got in your truck... whats another 1500$ for a bad *** Injection Pump?
If i were you id tap the pump for the ADR and run smarty with no timing. With the money you got in your truck... whats another 1500$ for a bad *** Injection Pump?
#18
Id say, yes BUT if you want to make sure you can remove the 3 bolts holding you throttle position sensor on and move it over a bit. You will see the top of the VP44, there are 2 connectors on the top, if its tapped one of the wires will have a wire tied into it trailing back to your Edge Att or Quad ADR
---AutoMerged DoublePost---
Go here http://www.quadzillapower.com/files/...98-02_6_09.pdf
Look at page 6
---AutoMerged DoublePost---
Go here http://www.quadzillapower.com/files/...98-02_6_09.pdf
Look at page 6
Last edited by DieselWeasel; 03-14-2010 at 10:27 PM. Reason: Automerged Doublepost