Traction Bar Mounting
#1
#2
Theres nothing wrong with welding them right on, just alternate your welds so not to heat the axle too much in one spot. here is a build thread for a set on a 3rd Gen.
traction bars
traction bars
#3
#4
Hey guys I got the bars finished finially, just have to mount them tomorrow. Just one more question, when I go to mount them should I have them at the short position so I can extend them when loaded?
My hiem joints only have about 2-2.5" of thread and my jam nuts are about 3/4" thick. If I go in the middle I woulnt have too much adjestment left. Ideas?
My hiem joints only have about 2-2.5" of thread and my jam nuts are about 3/4" thick. If I go in the middle I woulnt have too much adjestment left. Ideas?
#6
Thread
Thread Starter
Forum
Replies
Last Post
carid
Diesel Bombers Sponsors
0
09-02-2015 06:56 AM
Cumminsfreak24
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
01-21-2015 09:10 AM